without the 24V power supply for the BOOST-DRV8711 module enabled, the MSP430 launch pad UART works as expected for the GUI app of the BOOST-DRV8711_FIRMWAREv1.0 project.
the MSP_uart_monitor/Uart_demo_app project of http://processors.wiki.ti.com/index.php/ProgramModelUart_GuiComposer works well too.
but after the 24V power supply for the module enabled, and start the GUI preview, the UART failed to load symbols for both projects with the many error messages, the following is just a few of them.
ComPort: Trouble Reading Memory Block at 0x296 on Page 0 of Length 0x4: **Error**: Serial Communication failed at port: COM10, baud rate:9600! To use serial monitor, please ensure the following prerequisites are satisfied: 1. Make sure the cable is plugged into both the target and the host on the right COM port. 2. Make sure a compatible target side serial monitor is loaded and running on the target device.
ComPort: Trouble Reading Memory Block at 0x2e0 on Page 0 of Length 0x2: **Error**: Serial Communication failed at port: COM10, baud rate:9600! To use serial monitor, please ensure the following prerequisites are satisfied: 1. Make sure the cable is plugged into both the target and the host on the right COM port. 2. Make sure a compatible target side serial monitor is loaded and running on the target device.
ComPort: Trouble Reading Memory Block at 0x25c on Page 0 of Length 0x2: **Error**: Serial Communication failed at port: COM10, baud rate:9600! To use serial monitor, please ensure the following prerequisites are satisfied: 1. Make sure the cable is plugged into both the target and the host on the right COM port. 2. Make sure a compatible target side serial monitor is loaded and running on the target device.
if enable the 24V power supply after the MSP430 launch pad debug session started, it shows critical error message:
and after a while, the task manager shows that CCS6.0 IDE have no response any more and need to be killed by task manager.
export the GUI app to a zip file, then extract it to the i:\ti\ccsv6\webapps\ folder, the lancher.exe exit immediately when run it.