Sir, I am using DRV8332 in my project to control Maxon BLDC motors.
I have prepared a hand soldered circuit as mentioned in the datasheet. But the OTW, FAULT,Vref pins are coming low.
when no pull up resistors are added between the OTW/fault, the voltages are <1 V. when pull up resistor of value 4.7k each is connected to pull these pins to 5 V, the voltages are 4.4 and 3.8 V respectively. But it should be in the range 4.5 V to 5 V for considering a high logic!