Hi Texas Instruments!
I'm using the DRV10975 in a project were it is to be operated in a stand-alone (similar to how the DRV11873 is operated) mode by programing the spin-up profile of the used motor to the EEPROM on the DRV10975.
I have read the discussions regarding the programing of the EEPROM on this forum and there seems to be a lot of debate about the voltage required to program the EEPROM (higher than the maximum rating of the device). Could you specify the required voltage and best procedure to program the EEPROM? My PCB layout is the same as for the demoboard for the DRV10975.
Regards,
Niklas